Thanks to the support of all backers at Crowd Supply, ANAVI Info uHAT has been successfully funded and has hit all stretch goals so we proceed with manufacturing. This week we received from the local factory the first batch of almost fully assembled boards. Only the EEPROM is missing. We will flash and solder it in-house.
The printed circuit board of ANAVI Info uHAT has a green solder mask and a gold surface finish. There are a few steps more to complete the manufacturing process. An EEPROM has to be flashed and soldered on each board. It will contain software description of the add-on board following Raspberry Pi Foundation’s HAT (Hardware Attached on Top) specifications. After that each board will go through a quality assurance, and finally each kit will be packaged in a recyclable cardboard box.
Low-volume manufacturing is not an easy task nowadays, especially during a global chip shortage. As usual we will keep you updated. Thank you again for supporting ANAVI Info uHAT!
